<< Click to Display Table of Contents >> Navigation:  Dynamic OnLine I > The lists > Wire list > View device

Each wire in the wire list in most cases refers to two symbols in the circuit diagram, namely the symbol from which the wire goes, and the symbol to which the connection goes. For wires of connection type 1, this happens to be the same symbol, but the principle is still the same.

 

It can of course be interesting to find these symbols in the circuit diagram. In direct connection to symbols, you will have wire-number symbols containing wire-numbers and connection properties. These too might be interesting to find.

 

A special feature is available to make that easier. You use it in the following manner:

 

•Select a single wire in the wire list of Dynamic OnLine I by right-clicking it.

•Select View device.

•Choose between Connection out and Connection in. Please note that the wire-number symbol that contains connection properties for the current wire is the one on the outgoing side.

•When needed, cadett ELSA shifts to the drawing sheet where the symbol is placed, and then zooms in on the symbol in question. Shifting drawing sheet might lead to a need of answering a question if you want the current drawing sheet to be saved or not.

•To get back to the wire list in Dynamic OnLine I, you can for example select Wire list... in the Dynamic OnLine I panel of the Tools tab in the ribbon menu.