|
<< Click to Display Table of Contents >> Adjust wire-number positions |
  
|
|
<< Click to Display Table of Contents >> Adjust wire-number positions |
|
After inserting wire-numbers manually with the wire-number command, or automatically using the wire-number tab of Dynamic OnLine I, you might end up in a situation like showed in the figure below. This can of course be adjusted manually, which however requires a lot of work if the problem occurs frequently.
Figure 1111: Automatically generated wire-numbers with positions that are less than perfect.
If you execute an automatic adjustment, the result will be as shown in the figure below.
Figure 1112: An automatic wire-number adjustment has been performed.
In most cases this is sufficient, and of course therefore very time saving.