The “Initialise” panel

<< Click to Display Table of Contents >>

Navigation:  Drawing Environment > Ribbon menus > The "Alternative Document type" tabs > The “Alternative Document type” tab in Cable/harness diagram mode >

The “Initialise” panel

 Previous pageReturn to chapter overviewNext page
Figure 757:  The "Initialize" panel

Figure 757:  The "Initialize" panel

 

The Initialise panel does not have a slide-out panel. All commands are directly visible and explained below.

 

Command

Description

Initialise Circuit diagram

Please refer to the topic that describes the Initialise panel in Circuit diagram mode.

 

Initialise Cabinet layout

Please refer to the topic that describes the Initialise panel in Circuit diagram mode.

 

Initialise Cable/harness diagram

Please refer to the topic that describes the Initialise panel in Circuit diagram mode.

 

Initialise Wiring diagram

Please refer to the topic that describes the Initialise panel in Circuit diagram mode.